You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
glow-worm
Glowworm or glow-worm is the common name for various groups of insect larvae and adult larviform females that glow through bioluminescence. They include the European common glow-worm and other members of the Lampyridae, but bioluminescence also occurs in the families Elateridae, Phengodidae, and Rhagophthalmidae among beetles; as well as members of the genera Arachnocampa, Keroplatus, and Orfelia among keroplatid fungus gnats.
hi i am having a problem with a glow worm 70 cf the pilot goes out after 20 mins running i have serviced and cleaned the boiler carried out smoke pellet test all ok i have changed the pilot assembly complete kit with new injector new thermocouple boiler is running at 11.3 hot burner pressure in...
Hello gents,
We have a Glow worm 60FF Micro - which makes boiling noises only when the hot water is on. My expertise is limited so please take it easy with technical info.
The 60FF did make this noise about a month ago but it stopped after a few days.
Any test I can do to find out...
Benesen
Thread
boiling
glow
glow worm
glow-worm
hot
hot water
micro
noises
oil
water
worm
I have glow worm 24c combi boiler. The hot water flow rate is next to nothing, at all outlets. Mains water pressure is good. One other problem was the rads getting hot when hot water only.
Thinking this must be caused by the diverter valve not working correctly and that the dhw heat...
hestia
Thread
betacom
expensive
flow
flow rate
glow
glow worm
glow-worm
hot
hot water
parts
problem
water
worm
glow worm hxi30 boiler f9 fault code. no low water pressure switch on this boiler.and blown fuse second on pcb (does tis mean board gone?) main board
pump external to boiler. grundfos 25-80
slight history of job, arrived to fit dual fuel cooker gas hob electric oven. fitted
connect l.N.E to...
vic66
Thread
before
blown
board
boiler
code
cooker
fault
fuse
glow
glow worm
glow-worm
main
means
oil
pcb
switch
worm
One of my guys installed a Glow worm ultracom 2 in a flat just over 2 years ago. Everything has been fine until last Friday when I get a call saying water was pouring out the bottom of boiler. Had one of my other guys go look at it and he said water had stopped but when he topped it up water...
Every winter without fail this boiler throws an F1 code a couple time a week. What I find strange is that a quick reset does not help, it tries to fire up but fails again, however, if you leave it switched off for 10 minutes and then turn it back on, it fires up. Anyone know what the issue could be?
theOtherMrMike
Thread
boiler
engineer
every
glow-worm
ignition
reset
working
Hi all have one of these in a customers house that a bit of a head scratcher
heating runs fine but no hot water.
Turned of the power removed the motor on the diverter turned the power back on and the motor powers forward.
With the head removed and power on we get hot water.
So I changed...
Hi
i have an old floor standing cast iron gas boiler (glo worm) which provides our central heating. I think it has imperial nuts and bolts and it feeds a micro bore heating system.
The boiler looks like it has finally given up the ghost! One of the heat exchangers has failed and started leaking...
I have a problem with an ultracom 30 cxi, boiler fires temp rises quickly, boiler goes off and cools quickly, fires up again and keeps repeating. This is happening on heating & hot water.
Got one of these with ch water tracing up the flow when the hw is in use, Iam I right in thinking changing the diaphragm on the diverter valve will solve this? or will the whole valve need to be replaced?
thanks in advance guys & bah-humbug
Went to this job last week and it just sat at 35 degrees on the boiler, which is basically tick over mode
i pulled the stats off the flow and return pipe work on the boiler and then after a few minutes it whirred into life, so I thought ok, the thermistors must be on their way out so I changed...
Been to this boiler as it had a leak on the prv.
been back again as its still dropping pressure,prv is tight, no leaks in the house,i have checked everywhere and its baffled me as to where it can be, i checked the main exchanger, nice and dry.
i disconnected the filling loop to make sure it...
Glow worm Ultracom 30cx combi.
Was unable to set boiler into min or max rate in order to check/set co2 readings.
MIs say press reset button then quickly press and hold the "+" button until "Hi" is displayed, but there is no "+" button on the user control?? Took off the back of the control panel...
Good Morning Everyone,
I have a Glow Worm 30cxi Condensing Combi Boiler.
Last week, the main pcb died. I got the board replaced (4000124180). Boiler came back on, happy days.
I did notice that the water was nowhere near as hot as it should be and been advised the Plate to Plate Heat Exchanger...
SlammerUK
Thread
30cxi
advice
blowing
glow
glow worm
glow-worm
main
pcb
worm
Evening all.
Fitted the the boiler on Friday, Commissioned it using test mode, handed over to sparks for wiring up the controller, Mid position valve, Room stat and cylinder stat.
They couldnt figure it out, GW (Vaillant) Tech support don't work at weekends despite the fact that they claim...
Hi all went to one of these the other day and it's got me scratching my head.
The hot water temp was fluctuating greatly, running hot cold with the boiler cutting in and out.
Took the plate heat ex out gave it a bath in some nasty acid I've got, usually does the trick puts the it back and...
hello. i got problem with timer. i broken plastic part for switching on or off. i need to change time. maybe somebody know can i use 0020095196 (number of timer) its good for my easicom boiler? thank you
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.