Search the forum,

Icos HE24 showing L-F code.

Post new thread

Discuss Icos HE24 showing L-F code. in the Central Heating Forum area at PlumbersForums.net

D

Dave Strett

Icos HE24 showing L-F code. If i reset it goes into start up mode. Can hear burner fire but accompanied by a bubbling/gurgling then goes into L-F .
 

Reply to Icos HE24 showing L-F code. in the Central Heating Forum area at PlumbersForums.net

Similar plumbing topics

A
Emergency Stop Buttons in Boiler Rooms
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
266
oz-plumber
O
P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
209
ShaunCorbs
ShaunCorbs
Lou
    • Like
Who Is Darren the Plumber from Stockport?
Did anyone watch Britain's Got Talent last night? There was a Plumber on from Stockport called Darren who bottled it last year but did his audition last night.. He was a stand up comedian and he got off to a rocky start but by the end everyone was loving him! Does anyone know him? Is he a...
Replies
2
Views
137
Lou
Lou
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
343
Timmy D
T
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
191
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tilers' Talk
Electrician Talk Forum
Electricians' Talk
TilersForums.co.uk
Tiling Tools
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock