Search the forum,

How to adjust height of dishwasher

Post new thread

Discuss How to adjust height of dishwasher in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

J

jsm

Messages
25
Hi

Beko UDW601 integrated dishwasher, fitted but without side screws apparently. Want to level it off but not sure which to adjust screws to adjust to ensure it's level before fixing side screws..

Thanks
 

Attachments

  • image.jpg
    image.jpg
    445.5 KB · Views: 22
It’s not the torx grey ones is it ?
 

Reply to How to adjust height of dishwasher in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
210
SimonG
SimonG
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
202
Timmy D
T
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
275
exedon2
exedon2
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
200
dreikher
dreikher
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
357
Chuck
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Electrical Forum
Electrical News
Tilers Forum
Tilezine Tiling News Tile Association
Tiling Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock