Search the forum,

3 tap hole basin mixer tap

Post new thread

Discuss 3 tap hole basin mixer tap in the USA area at PlumbersForums.net

M

Matt0029

Gas Engineer
Messages
1,137
Are the tap hole centres on most 3 hole tap centres the same? Have to swap the taps in one that has 200mm centres for the taps with the spout in the middle. Thanks.
 
Didn’t the replacement cartridges work Matt ??????
 

Reply to 3 tap hole basin mixer tap in the USA area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
147
Lou
Lou
P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
216
ShaunCorbs
ShaunCorbs
D
UK Can't get stopcock 100% closed to allow a tap repair
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
253
Chuck
C
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
354
Timmy D
T
B
Brass tap body is leaking.
I have attached an image of the brass body within a tap. Having replaced a cartridge which has cured a leaking tap, I can see that there is a small leak from the brass body which can be unscrewed. Is there a seal behind the body? Thanks.
Replies
2
Views
311
Bp89
B
Creating content since 2001. Untold Media.

Newest Plumbing Threads

UK Tiling Forums
Electrical News
British Standards in Tiling BS5389
UK Tiling Forum
UK Tiling News
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock