You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
height
Height is measure of vertical distance, either vertical extent (how "tall" something or someone is) or vertical position (how "high" a point is).
For example, "The height of that building is 50 m" or "The height of an airplane in-flight is about 10,000 m".
When the term is used to describe vertical position (of, e.g., an airplane) from sea level, height is more often called altitude.
Furthermore, if the point is attached to the Earth (e.g., a mountain peak), then altitude (height above sea level) is called elevation.In a two-dimensional Cartesian space, height is measured along the vertical axis (y) between a specific point and another that does not have the same y-value. If both points happen to have the same y-value, then their relative height is zero. In three-dimensional space, height is measured along the vertical z axis, describing a distance from (or "above") the x-y plane.
Q1). RAD above height of CH Boiler & Expansion Tank? IDEAL ELAN 2 RS30: Vented/Semi Gravity CH System?
or feasibly this would prevent the CH system from working properly, as it lacks the force to supply water in an upwards direction even with an EXTERNAL PUMP after the CH BOILERS FLOW output...
Hi all. Just wondered whether most plumbers level a bath to a certain height before putting it in position and fixing? Or do you put the legs on and level it in position according to the height of the panel?
Hi - after a quick bit of advice....
I have an internal cloakroom (with shower/wc/basin) with an internally vented soil pipe. This is the only room draining into this 'stack' which is at ground level and then runs away under concrete slab of our garage into sewer.
Currently the air admittance...
Hi, renovating my bathroom and need some advice about the air admittance valve I have in place. It was all boxed in but I would like to hide it in a toilet / vanity unit. Is it ok to cut down?
thanks
anyone know the make of this float fill valve and how to separate it on the height adj as need to replace it - tried the washer and no joy - I would normally fit a fluidmaster but the toilet is a back to the wall pan an has been tiled around pan and no nailed to the floor.
buckley plumb
Thread
around
float
float valve
fluidmaster
height
master
valve
washer
Hi all.
I'm new to this forum and would appreciate some advise/ pointing in the right direction for a horizontal or short vented thermal store. A customer has 4 bathrooms, 24 radiators and 2 UFH zones and wants to upgrade his system(currently a baxi regular boiler 36kw and a standard vented...
hi, on a vaillant turbomax 242 or 282, does anybody no how much room you need to take the expansion vessel out from the top? as in, from the top of the boiler to the ceiling? also its sqaure and not round, hope someone can shed some light, thanks jon
Hi guys,
We're just finishing off a living room after knocking through to give us more space.
Plasterer is coming in the next few days to board the walls, and I have dropped 2 legs down the wall for the flow and return for the new rad that will be going in.
My question is, at what height do I...
Hello folks, I have a 0.2 bar Mayfair Cosmos monobloc single sink tap that has fairly low pressure (takes a bit longer get the hot water out), its a bungalow. and the height from the sink to the water tank in the attic is 5 1/2 foot so under the 2 metres required gravity etc, would this make...
noel6072
Thread
advice
correct
difference
height
pressure
tap
water
Hi,
I have a shower cubicle which has what looks like a silicone border (marked in black in photo A) that separates the tiles from the shower pan.
This is wearing out and is starting to get gaps in it.
I bought a basic silicone sealant, but I am not sure if this is the right tool for the job...
Hi, i'm putting in a wall hung toilet in and was wondering how high to hang the toilet on the frame?
I realise it can vary, but i'm after a typical figure from the floor to the seat.
I'm currently building a new house and have bought an underground storage tank. The tank is 50m from the boiler room where I will have 2 boilers ( 1 for UFH/HW and 1 for the swimming pool). What I need to know if what size pipe do I need to run from the tank to the boiler room to make sure...
Jez
Thread
boiler
boilers
height
metres
oil
oil tank
pipe
suction
tank
work
Hello all I hope you all had a good Christmas. What is the normal measurement from the bottom of a toilet to the center of the waste hole as I need to install the soil waste before the toilet is purchased. Is there a standard measurement for all toilets or does it differ? Thank you all.
Hi all, is there a minimum height for a washing machine waste trap (jockey stick type)? Seem to recall that it should be no less than 18". Went to a job today where the length was about 10" max, washing machine had been backing up unnoticed for weeks till flat owner below returned from holiday...
Hey I have fitted many close coupled toilets and have no problem with these. Can any one offer any advice on installing low level toilets. Is there an easy way to no what height to put the L brackets that hold the cistern in place? Is the pan best fit first or the cistern. Any advice and tips...
Hello guys....I'm installing a boiler on the second floor (ground....first.... second) any suggestions on how to reach the flue outside to complete cement and cowl.? Cheers D368
Hi, I would be grateful for your advice. I've got to replace an old ballcock on the cwsc. I will be fitting a Pegler part 2 valve and a new float. I just wondered how high or low to set the float because there is only a 2 metre head above the bathroom taps. Thanks in advance.
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.