Search the forum,

Discuss Towel rail advice - dual fuel, rather than just electric? in the USA area at PlumbersForums.net

Messages
35
Hopefully this is a quick one...
I'm currently building a house (well, my builder is, I'm doing a few of the jobs myself). Originally, we were going to have electric towel rails in the bathrooms, because we were going to have solar panels. We're over budget, so the panels will have to wait. Thanks to advice on here, I also changed my mind about the hot water loop being copper (rather than plastic). As such, I'm thinking it would now be best to have dual fuel towel rails on thermostatic valves with timers. Does that sound like the right move? We've four bathrooms, so I'm mindful of the bills racking up, if I get this wrong.
Also, what makes would people recommend for the DF towel rails and valves, please?

Edit: in case it's not already clear(!) I'm a DIYer, not a pro.
Edit2: it's just for drying towels btw, the bathrooms will have UFH.
 
The key to success with using the electric elements in dual fuel radiators is to have decent, easy to use timers so you don't waste electricity.

Ask the spark on the job for recommendations - there are some now which have APPs which make them really easy to set up and change
 
The key to success with using the electric elements in dual fuel radiators is to have decent, easy to use timers so you don't waste electricity.

Ask the spark on the job for recommendations - there are some now which have APPs which make them really easy to set up and change
Didn't even realise until last night that you buy them separately. Great tip - thanks!
 
Resurrecting this thread as I'm thinking of adding elements to two existing towel rails for summer use (using Hive activated timers)

Blunt question: Are the elements any good/effective for drying towels? . . . and if so recommended brands.
 

Reply to Towel rail advice - dual fuel, rather than just electric? in the USA area at PlumbersForums.net

Similar plumbing topics

Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
258
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
141
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
347
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
247
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
263
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock