Search the forum,

Shower valve model identification

Post new thread

Discuss Shower valve model identification in the USA area at PlumbersForums.net

C

Charliecloud

Messages
1
We had this shower installed in 2001 and yesterday the flow valve started to go on the blink. The knob has become harder to turn both on and off and the water shuts off. I can access the unit and I know how to isolate it and I am a pretty dab hand at 'stuff'

Can anyone identify the model . I am sure it was a Mira unit, but thats it. I am hoping I can buy a new service kit for it and repair it. There is not enough room to take it out completely and put in a complete new unit

Thanks for any advice
Thumbs Up
 

Attachments

  • DSC02665.jpeg
    DSC02665.jpeg
    63.8 KB · Views: 2
  • DSC02666.jpeg
    DSC02666.jpeg
    77.6 KB · Views: 2

Reply to Shower valve model identification in the USA area at PlumbersForums.net

Similar plumbing topics

F
  • Question
No Hot water, Fixed and Broken Again Ideal Logic 24
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
117
Lou
Lou
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
107
Lou
Lou
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
319
Timmy D
T
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
241
exedon2
exedon2
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock