Search the forum,

Discuss West Sussex -Looking for an expert to plumb in ........ in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Emm

Messages
3
To connect existing macerator in downstairs wetroom (front of semi-detached) to soil pipe where the drain cover is at the back and inside a conservatory.
 
What is the room directly above and any rooms on either side.
(Apparently my posts are being held and cleared again, what have I done this time?)
 
Not entirely sure it can be done properly tbh, measure the total length of the pipe run from back to front of the house then check the manufactures instructions for the fall on the pipe that they state is required. The only companies I know in W.Sussex are Saniflo Solutions & Pumpmaster but there are some one man band indies in that area.
 
Not entirely sure it can be done properly tbh, measure the total length of the pipe run from back to front of the house then check the manufactures instructions for the fall on the pipe that they state is required. The only companies I know in W.Sussex are Saniflo Solutions & Pumpmaster but there are some one man band indies in that area.

Thankyou. I’ve found a local drainage company, Drainflow Solutions, who are looking into it for me.
 
What is the room directly above and any rooms on either side.
(Apparently my posts are being held and cleared again, what have I done this time?)

your in the find a plumber section which means all posts are modded
 

Reply to West Sussex -Looking for an expert to plumb in ........ in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
216
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new thread so what's the best way of connecting the two? Cheers, Peter
Replies
2
Views
159
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
201
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
0
Views
115
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON IT PRISES OFF AND INSIDE THERE ARE SOME PLASTIC BITS AND A SMALL CROSS-HEAD SCREW IN THE MIDDLE. THANKS
Replies
6
Views
196
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock