Search the forum,

Discuss So this fell out of my potterton Combi heatmax HE in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
2
upload_2018-12-17_23-4-24.jpeg


Can anyone tell me what it is please and how to put it back?

Thanks
 
If your boiler still works then it was just sitting in the case, this part is available as a spare on that boiler. The chances of it just falling out are slim to none.
However imo if you've had an engineer that feels it's necessary to leave an old coil in the boiler for any reason, then it won't hurt to get someone to look over it for you
 
View attachment 35977

Can anyone tell me what it is please and how to put it back?

Thanks
As others said, it's a solenoid coil. From the gas valve, which wasn't said and you may not have guessed.
If you have a multimeter, it's worth checking it's faulty, most likely open circuit. I had one fail on my boiler a couple of years back. I didn't leave the old one lying around inside the boiler though!
 
Thanks guys - it was a new boiler replaced 3 years ago and no issues with it. The coil fell out about two years ago and the boiler continued to work fine. It's only now I'm renting the flat I wondered whether it was an issue.

It seems that it isn't because it's basically impossible for one to just fall out.

Thanks for all the assistance.
 
Thanks guys - it was a new boiler replaced 3 years ago and no issues with it. The coil fell out about two years ago and the boiler continued to work fine. It's only now I'm renting the flat I wondered whether it was an issue.

It seems that it isn't because it's basically impossible for one to just fall out.

Thanks for all the assistance.
Sounds like it was left inside in the factory. I would still check it, and if it's OK you have a spare.
 

Reply to So this fell out of my potterton Combi heatmax HE in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
178
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
4
Views
183
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
401
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
111
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
2
Views
147
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock