Search the forum,

Potterton powermax he85

Discuss Potterton powermax he85 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
D

darren crossley

Messages
3
Hi

Does anybody know what the error code a27 signifies? It' not listed in the user manual.

Thanks
 
SimonG said:
Probably one that needs a gas safe engineer to rectify.
Click to expand...

Hi, thanks for responding. Have had an engineer and he recommended a powerflush without really seeming to know what the fault was. Was hoping that someone may have come across this specific error code and could advise.
Thanks
 
Yep just checked no A27 fault code .

You could ring Baxi tomorrow ( good luck , you will need it )
However they may need a GS no first.
 
Status
Not open for further replies.

Reply to Potterton powermax he85 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
5
Views
138
DIwhYdidIstartThis
D
J
Leak detection company
Does anyone know a good, not super expensive, leak detection company in the London area?
Replies
0
Views
277
John-sjw
J
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
118
dreikher
dreikher
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
428
Chuck
C
B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
167
ShaunCorbs
ShaunCorbs
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock