Search the forum,

Discuss Glow worm energy boilers in the Gas Engineers Forum area at PlumbersForums.net

Scott_D

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
6,131
Anyone fitting these?
Can you pay to extend the warranty to 10 years like Vaillant?
 
Hey. Fitted a fair few. Yes you can pay to take it up to 10 years. £84.99 i believe. The glow worm installers app is exactly the same set up as the Vaillant app (know its the same company) and pay you £30 per installation/registration via the app. Good boilers and a lot cheaper then the Vaillant. Had a couple of call backs due to loud clicking noises from the main heat ex and pressure sensor faults. Glow worm came out and fixed under warranty very quickly.
 
Hey. Fitted a fair few. Yes you can pay to take it up to 10 years. £84.99 i believe. The glow worm installers app is exactly the same set up as the Vaillant app (know its the same company) and pay you £30 per installation/registration via the app. Good boilers and a lot cheaper then the Vaillant. Had a couple of call backs due to loud clicking noises from the main heat ex and pressure sensor faults. Glow worm came out and fixed under warranty very quickly.
is the display/installer level the same as vaillant or different?
 

Reply to Glow worm energy boilers in the Gas Engineers Forum area at PlumbersForums.net

Similar plumbing topics

Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
184
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
172
Has anyone one fit or serviced one of these before; Heatrae Sadia 25l 9004010. It a 25 litre hot water storage cylinder.
Replies
39
Views
562
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
256
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
122
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock