Search the forum,

Baxi training centres

Discuss Baxi training centres in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
A

allwright

Has anyone attendeed Baxi training centres, are they any good
 
Yes, well worth going too, learn't bit of fault finding and few gremlins with the range and how to put right, nice ring binder of current range liturature and servicing manuals, nice snickers polo, baxi bleed key etc.. did last summer when not too much on, all good.
 
Status
Not open for further replies.

Reply to Baxi training centres in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

J
Leak detection company
Does anyone know a good, not super expensive, leak detection company in the London area?
Replies
0
Views
291
John-sjw
J
M
heatrae sadia 25l 9004010.
Has anyone one fit or serviced one of these before; Heatrae Sadia 25l 9004010. It a 25 litre hot water storage cylinder.
2
Replies
39
Views
626
John.g
J
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
276
oz-plumber
O
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
175
SimonG
SimonG
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
171
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock