Search the forum,

Discuss Baxi boiler needs topping up daily in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
6
Hi, we've got a Baxi Combi 105 HE boiler which is about 13 years old. It needs water adding every time I put it on as it keeps dropping 0. I was going to nurse it through another winter but I'm thinking things must be dire now. How much would a like for like replacement be with fitting, a guesstimate?
 
It my need a service. Have an engineer come out and service boiler and explain about the pressure loss. Most will be on the part that is causing it straight away and should be checked as part of the service, If it continues after that you may have a leak on the heating system.
 
Check the p.r.p. out side see if it is dripping when boiler has been on for 10 mins.
Small copper pipe outside
 
Evening @Ban70. This could be a number of things, from a large leak on the system, to a part failure on the boiler. Can you top the pressure up to just above 1 bar and put the heating on please. Can you then watch the pressure and see if it rises to above the 3 bar on the pressure gauge.

Please like this post if you found it helpful.
 

Reply to Baxi boiler needs topping up daily in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
5
Views
138
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
255
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
5
Views
131
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
118
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock