You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
motorised
12 Motorised Infantry Brigade (pronounced as One Two Motorised Infantry Brigade) is a brigade of the Namibian Army based at Keetmanshoop. The prefix "12" is taken from 12 May 1929, Namibia's first president's birthday day. The brigade is responsible for the defence of the southern areas of Namibia. Its subordinate units are situated in the Omaheke, Hardap, Karas and Erongo regions.
I have tried hard to get similar to the first class satchwqell /Sunvic SML type revolving type valves instead of the quite short lived spring return type valves.
I saw an advert from the Hearken company who either make these or buy them in. The only problem they are BSP threads so adaptors are...
We have a Drayton 27101 - 3 port motorised valve 22mm compression
Issue: when heating switches on there is no hot water, when you switch heating off you get hot water.
I replaced the motor in the motorised valve, everything started to work like it should. But an hour later and the same...
Hi Folks,
Please advise as i wish to change a motorised valve connected to a heat only gas boiler:
Turn off the boiler
Turn off the mains water
Find a draining point and drain system
Replace motorised valve
Make sure draining point is closed.
Turn on mains...
When either of the 2 port motorised valves closes, I get a loud clunk. A Honeywell automatic bypass valve was fitted a year or so back to replace a gate valve bypass. I'm happy its in the correct position & orientation, Its set to 0.2 bar. I don't believe we had this clunk last year.
I suspect...
Hi,
We are designing and building cooking gas bottles with electronics controlled valves. These are for kids camping chalets. Its purely a safety feature because its kids. As you can tell, there is no big market for this product, its just to get these kids out camping.
System description:
So...
Hi guys and gals,
I'm looking to try to change from a Y-plan to an S-plan-plus this year to have a heated bathroom. While the house isn't that large, a mixture of south-facing brick and north-facing (and Jerry-built) timber frame construction means no single thermostat will cut the muster...
Hi all! as I am attempting my first plumbing project and the stakes are high, I would greatly appreciate picking your experienced brains regarding valves. I am building an overland truck/motorhome and since I will be traveling to remote areas and underdeveloped countries I'd like my plumbing...
Hi guys, our conventional oil boiler heating system has only ever heated our radiators and our hot water at the same time; we have no isolated hot water control, just a timer that does both. I'd love to be able to just heat our hot water from the boiler during the summer.
I had a look in our...
Just discovered a loud ticking noise coming from the boiler area and the zone valve seems to be causing it with a metal lever moving in one direction then resetting and trying again.
It's only just started and system is new, less than 6m full CH replaced, pipes/rads/boiler/magnetic filter etc...
I'm needing to replace a Drayton Mid Position valve Actuator, code MA1. The failed one is 3-wire (red, green, black) but all the new ones I've found advertised are 5-wire (yet the cover data plates are identical!).
Question is - can I replace the 3-wire actuator with a 5-wire, and if so how...
So, I went to this job yesterday to change over a faulty motorised valve on the hot water side of an unvented system. I drained the system, wired the new one up and fitted the new valve, this system is fed from a communal boiler in the building which might be part of the reason for the issue I...
Ours are lasting between a year and two years and then I have to replace. Is this normal or should I be investigating our central heating system to find out why?
Which motorised valves do you recommend I use?
Hi again
I'm on a roll with the plumbing questions today! So here's query #2...
We've not used our hot water for quite some time, and it now doesn't work. From what I can gather based on what I've learnt in the last hour or two, I think the problem is with the 3 port motorised valve. When...
I have a Honeywell value (V4073A1039) which doesn't seem to be operating correctly, basically not opening when using heating and not closing when using water. The issues is shown in this video.....
Morning
Is there a maximum distance from the megaflo that the hot water motorised valve connected to the cyl stat ?
moving tank from cupboard to attic
Cheers
recurring Issue, any help would be greatly appreciated.
I have changed this valve twice in the last 3 years........ is this normal or would i expect to get longer use out of this valve?
Hi
has anyone ever come across a orkli 2 port motorised valve60520604(silver case) I only need actuator but finding it hard to source exact replacement, also do you know if the actuator can be replaced on this model without draining. Im only familier with honeywell and drayton. If not no...
Evening all, hoping someone can shed some light on this issue. Heating works fine, though as soon as you turn on the hot water, it shuts the boiler off. Turn it off and the boiler comes back on. The motorised valve body turns freely by hand with valve head taken off and if placed in hot water...
as you can see someone has previously removed the cover so I can't find a make or serial number to buy a replacement. Has anyone come across this valve before?? or if its a standard size and most valves should fit with the current pipe work
TIA
Hi
i checked the wiring colours are the same from the junction box to the current 3 port valve, as the new one. But although I could turn off the house mains, I would prefer not to, is it easy to tell if the wires are live, using a multimeter, ? Have an isolation switch, but not 100% sure if...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.